Do NOT plug the USB receiver into your computer yet...you must install the correct drivers first.
Locate the 702 driver’s folder on the installation CD and install the wireless camera drivers and camera watcher program.
Reboot
Plug the USB receiver into your computer, the system may install the drivers again.
Ensure that the small power switch on the USB receiver is set to on.
Launch the Wireless Camera Watcher program and click on video settings. Change the video format to NTSC_M.
Ensure that the Video compressor and audio device are set to your default video and audio devices installed on your computer.
Cycle the receiving signal on your USB receiver threw channels 1,2,3 and 4 to find which signal your camera is operating on.
